Frame Height Cylinder Phasing; Put The Frame Height Cylinders In Phase - CONCORD NT30 Operator's Manual

3.8 Frame height cylinder phasing

When the support cylinders extend to the same length at the same time the support cylinders are in
phase. If the cylinders do not extend to the same length at the same time then the cylinders must be put
in phase.
Frame height cylinders that are out of phase will cause the machine to not be level with the ground when
lifting or lowering the machine. A frame that is not level to the ground will cause different seed depth
between each toolbar.

3.8.1 Put the frame height cylinders in phase

Before starting the procedure
To put the frame height cylinders in phase the machine must be connected to the correct size of tractor
to operate the machine.
Put the frame height cylinders in phase to make sure the cylinders are moving to the same length at the
same time.
Procedure
1. Lift the frame of the machine to the highest position.
2.
Hold the hydraulic lever in the raised position for five seconds.
After finishing the procedure
Make sure the frame height cylinders are phased by lowering the machine to the ground and raising the
machine to half of the fully raised height. If the frame is level to the ground then the cylinders are in phase.
Narrow-Transport Grain
Drill (322782B)
65
3. Operation
GUID-3BC586D2-4353-4E1E-8A17-1F19DEAA937D [V1]
GUID-F4F3F86D-4E3D-492E-9207-DFE9D9C1F173 [V2]