Assemble The Cast Boot - CONCORD NT30 Operator's Manual

8. Assembly

8.2 Assemble the cast boot

Procedure
1. Assemble the boot (1), hinge pin and torsion
spring as shown.
2.
Put the assembly tool (2) on the exposed pin.
3. Use a wrench to turn the tool until it touches
the spring.
4. Turn the spring until it goes past the retainer
slot.
5.
Put the spring retainer pin (3) into the
retainer slot.
Result
Make sure the pin is flush with the face of the
strut or it could fall out during operation.
6. Remove the assembly tool and install the retainer plates (4).
7. Install the two flat washers (5), lock washers (6) and 1/2 inch hex bolts (7).
8. Push on the top of the boot until the front edge of the boot evenly rides on the disc.
9. Tighten the two 1/2 inch hex bolts (7).
Fig. 1
142
GUID-511D4168-6011-4FF5-9408-2E1F2A3EE712 [V2]
GUID-CB9848E0-5912-4C18-8EBC-04809E9521AA-high.jpg [High]
Narrow-Transport Grain
Drill (322782B)