Toolbar Locks; Lock The Toolbar Locks - CONCORD NT30 Operator's Manual

1.6 Toolbar locks

Each toolbar has a toolbar lock (1). A toolbar lock
tool is used turn the lock in the slot (2) and lock
the toolbar. The toolbar locks are used to lock the
toolbars in the lifted position. Engage the toolbar
locks when transporting the drill or servicing the
toolbars.

1.6.1 Lock the toolbar locks

Lock the toolbars before transporting the drill or servicing the toolbars.
Procedure
1. Use the tractor hydraulics to fully lift the toolbars.
2. Stop the engine, set the tractor park brake, and take the ignition key with you.
3. Remove the toolbar lock tool (1) from the
storage position (2). Remove the wire lock
pin (3) that attaches the toolbar lock to the
light bar assembly.
4. Use the toolbar lock tool to push in and turn
the lock (1) clockwise to the locked position
(2).
The toolbar is locked when the lock is
pushed in and fully turned into the slot.
5. Use the same procedure to lock the
remaining toolbars on the machine.
Narrow-Transport Grain
Drill (322782B)
Fig. 29
Fig. 30
Fig. 31
27
1. Safety
GUID-A72C6079-D596-45F0-8718-C1B075BCDF7A [V2]
GUID-D9AFABDD-A489-4790-A45A-4B34E1F17C86-low.png [Low]
GUID-B1830DC5-2302-4170-A0FD-22B7AC9A0675 [V2]
GUID-31BBFFA0-6624-4B55-9C84-70F6B5BA697A-high.jpg [High]
GUID-93F8720A-8DA2-4FAF-822D-99BFDEBB5A31-high.jpg [High]