Isobus Harness Connector - CONCORD NT30 Operator's Manual

3. Operation

3.4 ISOBUS Harness Connector

GUID-A91F4984-F550-422E-9FFD-D50A4ED56598 [V1]
The machine has two connectors used to connect to the ISOBUS harness.
Front ISOBUS Connector
The front ISOBUS connector is located on the front hitch of the machine and is used to connect the
machine ISOBUS to the tractor. The front ISOBUS connector is a standard nine pin connector.
Rear ISOBUS Connector
The rear ISOBUS connector (1) is located in the
rear connection bulkhead and is used to connect
the machine ISOBUS to a pull behind implement.
The rear ISOBUS connector is a standard nine
pin connector.
GUID-C3B06079-F0A0-4BAF-B6A6-55757746099A-high.jpg [High]
Fig. 6
56
Narrow-Transport Grain
Drill (322782B)