Table of Contents
Advertisement
3. Operation
8.
Adjust the adjusting rods (5) above each of the wing support cylinders (3). Adjust the adjusting rod
until the measurement between the frame and the ground is the same. Adjust the adjusting rods by
tightening or loosening the jam nut (4) on either end of the adjusting rod.
9.
Make sure the measurement at each of the wing support cylinders is equal. Tighten the jam nuts
against the tube that holds the adjustment rod.
76
Narrow-Transport Grain
Drill (322782B)
Advertisement
Table of Contents
Troubleshooting
