Turn The Machine At The Edge Of A Field - CONCORD NT30 Operator's Manual

3.19 Turn the machine at the edge of a field

When turning at the edge of a field, or headland, complete the following steps.
Procedure
1.
When approaching the turn, slow the tractor and machine to an acceptable rate of speed to complete
the turn.
2. Begin to raise the frame of the machine and start the turn at a point where the machine will clear any
obstacles to the outside of the turn.
IMPORTANT: When lifting the machine for a turn, only lift the frame with the frame height cylinders.
3. Complete the turn. Watch and make sure the edge of the machine clears any obstacles.
4.
After completing the turn, align the machine with the last pass, permitting for the correct amount of
spacing or overlap.
5. Lower the frame of the machine to start the next pass.
6. Increase the speed of the tractor and machine to the operating speed.
Narrow-Transport Grain
Drill (322782B)
89
3. Operation
GUID-8DC6B186-4191-484F-8243-90F4F7A5300D [V3]