CONCORD NT30 Operator's Manual page 138

7. Accessories
3.
Place a wooden block below one of the discs
(1) on the fertilizer bander attachment that is
to be adjusted.
4. Start the tractor and lower the machine to the
ground.
5.
Stop the tractor. Stop the engine, apply the
tractor park brake, and take the ignition key
with you.
6. CAUTION:
Make sure the fertilizer bander
disc is firmly supported by the
wooden block. If the fertilizer
bander disc is not firmly
supported then start the tractor,
raise the machine, and
reposition the wooden block.
Remove the bolt (1) and washer (2) securing
one end of the cam block (3) for the bander
disc (4) being supported by the wooden
block.
7. Slide the cam block out of the bander frame.
8. Install the cam block in the bander frame so the desired depth groove in the cam block will contact
the bander disc strut.
9. Secure the cam block in the bander frame using the existing bolt and washer.
10.
Start the tractor and raise the machine until the bander disc is off of the wooden block.
11. Stop the tractor. Stop the engine, apply the tractor park brake, and take the ignition key with you.
12.
Remove the wooden block from below the bander discs.
After finishing the procedure
Use the same procedure to adjust the remaining bander disc on the fertilizer bander attachment and the
other bander attachments.
Fig. 3
Fig. 4
138
GUID-89BE80E5-4119-439D-8707-6DB6ED895C94-high.jpg [High]
GUID-B3754AD7-BBBD-482C-A431-E72EA8C9D707-high.jpg [High]
Narrow-Transport Grain
Drill (322782B)