Prepare For Assembly; Service Parts - CONCORD NT30 Operator's Manual

8.1 Prepare for assembly

WARNING: Components can be heavy.
Severe injury can result from improper lifting technique.
Use appropriate lifting equipment for heavy components.
Read this section carefully before assembly. Refer to the Parts Catalog for additional component
illustrations while assembling the machine.
Part numbers are shown on labels on the parts.
Hardware numbers are shown on labels on the hardware or on the container the hardware is in.
Carefully remove all the parts and hardware included. Make sure nothing was damaged or missing.
Tighten all hardware according to standard torque values unless specified in these instructions. See the
torque charts in this publication for more information.
Always replace hardware with the same grade or class.
Use all the nuts and bolts in the correct locations. This will prevent damage to the machine.
IMPORTANT: When two or more bolts are being used on a part, always insert the bolts and loosely tighten
the nuts. Once the correct location has been reached, tighten the nuts evenly to prevent misalignment or
distortion of the parts. Tighten all U-bolt nuts evenly and to the same torque to prevent misalignment or
distortion.
Select a large, flat, and hard surface for assembly of machine.
IMPORTANT: Keep all parts in the assigned containers until the parts are to be used.
NOTE: Some items will be assembled at the factory.
Right-hand and left-hand, as used in this manual, are determined by facing the direction the machine will
travel when in use.

8.1.1 Service parts

The illustrations and part numbers in this publication are supplied for component identification only when
assembling the machine. When ordering replacement parts, always use the part numbers from the parts
catalog.
For a complete list of available service parts, contact your dealer.
Narrow-Transport Grain
Drill (322782B)
141
8. Assembly
GUID-2509BB58-2EDD-4843-B787-C6201A238626 [V6]
GUID-0CC3542C-6DFD-442D-B388-BA47ED91B876 [V2]