Prepare The Machine For Seeding - CONCORD NT30 Operator's Manual

3.14 Prepare the machine for seeding

Before starting the procedure
The machine must be connected to a tractor that is the correct size to operate the machine. See
the information for the minimum tow vehicle weight.
Make sure there is enough area around the machine to completely lower the wings.
Procedure
1. Stop the tractor. Stop the engine, apply the tractor park brake, and take the ignition key with you.
2. Make sure the area below the machine is clear of people, pets, and obstructions.
3. Move the toolbar lock-out handle (1) to the
open position.
4. Start the tractor.
5.
Use the tractor hydraulics to remove any load
from the toolbar locks by fully lift the
toolbars.
6. Use the tractor hydraulics to remove any load
from the wing lock pins by fully lift the
wings.
7. Stop the engine and take the ignition key with
you.
8. Remove the wing lock pins (1) and wire lock
pins (2) from the wing lock brackets (3). Install
the wing lock pins in the storage brackets on
the frame.
9. Start the tractor.
10. Use the tractor hydraulics to lower the wings
to the operating position.
11. Move all the toolbar locks (1) to the unlocked
position (2).
12.
Use the tractor hydraulics to lower the
toolbars and move the hydraulic lever to full
down position.
13. Use the terminal to set the initial down
pressure.
14. Stop the engine and take the ignition key
with you.
Narrow-Transport Grain
Drill (322782B)
Fig. 28
Fig. 29
Fig. 30
73
3. Operation
GUID-1C0A6428-0CB9-47F0-918E-8C6175CE8703 [V2]
GUID-B6BF3DB2-FE9A-4241-9893-DBF2FA0D2A77-high.jpg [High]
GUID-1A9E5C47-CC3E-4796-B93B-ECEF777DC596-high.jpg [High]
GUID-93F8720A-8DA2-4FAF-822D-99BFDEBB5A31-high.jpg [High]