Text Message Alarm Notifications; Network Troubleshooting - Helios ICT Platinum Series Instruction Manual

5.10. Text Message Alarm Notifications

The Platinum Series Power Supply can send text message alarm
notifications to a cell phone by sending the alarm e-mail to an
address at the mobile phone provider. On the Network Setup page,
enter the address for your phone in one of the Recipient E-mail
Addresses field. For example, to send a text message to an AT&T
phone, enter cellnumber@txt.att.net, replacing cell number with your
10-digit cell phone number.
Here are some address formats for other mobile phone providers:
AT&T
Verizon
T-Mobile
Virgin Mobile
Nextel
Bell Mobility
Rogers
Telus
Virgin Mobile (Can)

5.11. Network Troubleshooting

I am unable to access the embedded Web server:
• Check that you are using the correct IP address to access the
power supply's embedded Web server by viewing the Network
Status screen on the Control Panel display (see the Control
Panel Menus section for instructions on how to access the
Network Status screen). The IP address for the power supply
may have changed if DHCP is enabled.
If the Network Status screen on the Control Panel display shows
•
Network Not Connected, check the network cable connections to
the power supply and the network.
Ensure that you are using the correct type of network cable. An
•
industry standard "crossover" cable should be used for
cellnumber@txt.att.net
cellnumber@vtext.com
cellnumber@tmomail.net
cellnumber@vmobl.com
cellnumber@messaging.nextel.com
cellnumber@txt.bell.ca
cellnumber@pcs.rogers.com
cellnumber@msg.telus.com
cellnumber@vmobile.ca
49