Helios ICT Platinum Series Instruction Manual page 47

1. Log in to your router and go to the port-forwarding screen. In the
Linksys WRT54G, this is located in the Applications and Gaming
tab. The location of port forwarding may be different on other
routers (consult your router manual for instructions).
2. To configure HTTP forwarding, following these steps:
a. Enter a unique name in the Application field.
b. Enter the HTTP port number that the power supply is using in
the Start and End fields. If you are using the default power
supply port settings, the port number is 80.
c. Select Both under Protocol (TCP and UDP).
d. Enter the local IP address of the power supply (e.g.
192.168.0.180) in the IP Address field. The current IP
address of the power supply can be found on the Network
Status screen (see the Control Panel Menus section for more
information).
e. Check Enable, and then click on Save Settings.
NOTE: Many ISP's block access to port 80. If your ISP does block
port 80, you will need to change the HTTP port the panel uses from
80 to something else, such as 8000. Valid port numbers are in the
range of 1 - 65535. See the Network Setup section for instructions on
how to change the power supply network ports.
You will also need to change the HTTP port number from 80 to
something else if your local network already contains another device
using port 80 such as another panel or a Web server.
3. To configure HTTPS forwarding, repeat steps 2a – 2e with the
HTTPS port number that the panel is using. If you are using the
default panel port settings, the HTTPS port number is 443.
47