Helios ICT Platinum Series Instruction Manual page 35

Activate Alarm Form C Contact: Tick this box to have the
•
back-panel Form-C relay trigger whenever the LVD relay
opens.
Send E-mail: Tick this box to have the unit send an e-mail to
•
the address configured in the Network Setup page whenever
the LVD is triggered.
Battery Over-current Alarm: Set the battery over current alarm
threshold and actions here.
Over-Current Threshold: Set the battery over current
•
threshold that will trigger a battery over-current alarm.
Disable the alarm by setting a threshold of 0 Amps.
Activate Alarm Form-C Contact: Tick this box to have the
•
back-panel Form C relay trigger whenever this over-current
threshold is hit.
Send E-mail: Tick this box to have the unit send an e-mail to
•
the address set up in the Network Setup page whenever the
Battery Over-current Alarm is triggered.
Battery Low SOC Alarm: Set the battery low state of charge alarm
threshold and actions here.
SOC Threshold: Set the battery low state of charge alarm
•
threshold that will trigger when the battery state of charge
falls below the set level. Disable the alarm by setting the
threshold to 0%.
Activate Alarm Form-C Contact: Tick this box to have the
•
back-panel Form C relay trigger whenever this low state of
charge threshold is hit.
Send E-mail: Tick this box to have the unit send an e-mail to
•
the address set up in the Network Setup page whenever the
Battery Low SOC Alarm is triggered.
Battery Discharge Test: Configure the Battery Discharge Test
settings in this section, so that you may either manually or
automatically perform a partial discharge test to gauge the relative
capacity of the external battery. Each time the test is run the output
voltage from the power supply will be reduced so that the external
35