Helios ICT Platinum Series Instruction Manual page 15

BATTERY STATUS SCREEN
The Battery Status screen is available when the Battery Backup
option ("B") is installed. View this screen to see the battery Voltage,
the battery Current (+ for charging, - for discharging), and if the
battery is Connected via the LVD contactor.
BATTERY SETTINGS SCREEN
From the Battery Status screen, press Enter to move to the Battery
Settings Screen.
The Battery Settings screen is available when the Battery Backup
option ("B") is installed. These settings allow you to adjust the battery
Low Voltage Disconnect (LVD) points, configure the battery
maximum charge current, float voltage temperature compensation,
Equalize charge settings and Discharge test settings.
Disconnect Voltage: Modifies the battery disconnect voltage.
If the battery voltage drops below the disconnect voltage when
in battery back-up mode, the battery relay will open and
disconnect the battery. There will be a 3 second delay until the
voltage disconnects. The Range of the Disconnect Voltage is
10 – 11.5V. (12V model)
Reconnect Voltage: Modifies the battery reconnect voltage
when in back-up mode. If the battery voltage rises above the
15