Router Configuration - Helios ICT Platinum Series Instruction Manual

password of the power supply, see the Administrator Password / IP
Address Reset section.
Export And Import Settings
The Manage Settings button will take you to the Export and Import
Settings page, where you may export all the system settings (other
than the Administrator password, Network and Web Server settings)
to an encrypted .cfg file on the local computer. Use the Import
Settings section on other systems to locate this file and then import it
to any other Platinum Series unit you are logged in to, greatly
simplifying the configuration of multiple identical units.
Firmware Update
Download the latest Platinum Series firmware file from the ICT
website (ict-power.com) to your local computer. De-compress this
file then press the Update Firmware button, and link to this file.
Update the firmware on the power supply by clicking the Update Now
button. Do not remove AC power during the update process!
Send Test E-Mail
Pressing the Send Test E-mail button will send test e-mail to the
specified recipient using the e-mail settings on the Network Setup
page.
Ping Diagnostics Tool
Use this feature to verify connectivity of any network connected device.
Enter the hostname or IP address of the target device, and then click
the Ping button to check if the device is active.
5.9.

Router Configuration

This section explains how to set up the embedded Web server
interface behind a router and enable remote access to the panel over
the Internet.
A router allows multiple PCs to share a single Internet connection. To
enable access to the Web server over the Internet, you will need to
configure your router to forward incoming remote data to the local IP
address of your power supply.
The following steps use a Linksys WRT54G router as an example:
46