Lubricating The Cot - Ferno Mondial MB64 User Manual

7.9 Lubricating the Cot

Disinfect and clean the cot before applying lubricant. Use the lubricants
designated below to lubricate the cot. Do not lubricate points marked
with the "do not lubricate" symbol.
LUBRICATION POINTS
1. Telescoping handle (4)
2. Shock frame hinge (2)
3. Loading-wheel linkage (4)
4. Swivel-caster lock pins (2)
Clear synthetic grease/Loctite® 39342 ViperLube® (rarely)
5. Airway management hinge (2)*
*If equipped
LUBRICATION-FREE ITEMS
Channel*
Rollers
Wheels (sealed bearings)
Leg pivot points
Backrest hinges
* The channels do not require lubrication. Lubricating the channels or rollers will
cause foreign particles to stick to the rollers and channel, causing damage.
1
32
Maintenance
WRL-191S or E-Z-1 (1-2 drops)
WRL-191S or E-Z-1 (1-2 drops)
WRL-191S or E-Z-1 (1-2 drops)
clean w/mild detergent/water (typical);
WRL-191S or E-Z-1 (1-2 drops)
Do not lubricate
Do not lubricate
Do not lubricate
Do not lubricate
Do not lubricate
2
3
Important
Lubricating parts that should not be lubricated allows dirt
and foreign particles to collect on those parts, resulting in
damage. Lubricate only the numbered reference points
shown.
Applying Lubricant
Use a small amount of lubricant (one or two
drops). Lubricate identical points on each side
of the cot. After applying lubricant, wipe off any
excess.
Do Not Lubricate
4
© Ferno-Washington, Inc. / 234-3480-06 / November 2017
Lubricate
1
5