Inspection And Maintenance Work - SEW-Eurodrive MOVIMOT flexible MMF1 C/DBC Series Operating Instructions Manual

9.3

Inspection and maintenance work

9.3.1 Preliminary work regarding inspection and maintenance
Observe the following notes before you start with inspection/maintenance work:
Risk of injury if the device starts up unintentionally, and danger of electrical voltage.
Dangerous voltages may still be present for up to 5 minutes after disconnection from
the line voltage.
•
•
•
Risk of burns due to hot surfaces.
Serious injuries.
•
9.3.2 Connection cables
Observe the notes in chapter "Preliminary work for inspection and maintenance".
Check the connection cables for damage at regular intervals and replace if necessary.
9.3.3 Replacing the gasket between connection box and electronics cover
Spare part kit
The gasket is available as a spare part (1, 10 or 50 pieces) from SEW‑EURODRIVE.
Content
1 piece
10 piece
50 piece
WARNING
Disconnect the device from the power supply with suitable external measures be-
fore you start working on the device and secure it against unintentional reconnec-
tion to the voltage supply.
Secure the output shaft against rotation.
Before removing the electronics cover, wait for at least the following time:
5 minutes.
WARNING
Let the devices cool down before touching them.
Inspection and maintenance
Inspection and maintenance work
Part number
18187765
28266161
28266188
Operating Instructions – MOVIMOT
9
265
®
flexible