Keysight Technologies X Series Service Manual page 70

Self Test
Running Self Test
Figure 4-2 Initial Self Test Message
If self test takes longer than 10 minutes to complete, go to
"Power Supply"
4. Press Run Complete Self Test.
Figure 4-3 Self Test Aborted Message
5. When Self Test completes, the messages in
70
to troubleshoot a possible power supply failure.
An activity bar displays on the screen indicating the test progress.
If you press Abort while Self Test is running, the message in
displayed.
tests pass. If there are any failures the message in
Keysight CXG, EXG, and MXG X-Series Signal Generators Service Guide
Chapter 8,
Figure 4-3
Figure 4-4 is displayed if all
Figure 4-5 is displayed.
is