Electrostatic Discharge (Esd) Protective Supplies; Handling Of Electronic Components And Esd; Test Equipment Usage And Esd; For Additional Information About Esd - Keysight Technologies X Series Service Manual

Overview
ESD Information

Electrostatic Discharge (ESD) Protective Supplies

Description
ESD connector end cap front-panel RF output
ESD connector end cap-GPIB
2 X 4 Ft. Antistatic Table Mat with 15 FT. Ground Wire
5 Ft. Grounding Cord (for wrist strap)
Adjustable Antistatic Wrist Strap

Handling of Electronic Components and ESD

The possibility of unseen damage caused by ESD is present whenever
components are transported, stored, or used. The risk of ESD damage can be
greatly reduced by paying close attention to how all components are handled.
— Perform work on all components at a static-safe workstation.
— Keep static-generating materials at least one meter away from all
— Store or transport components in static-shielding containers.
Always handle printed circuit board assemblies by the edges. This will
reduce the possibility of ESD damage to components and prevent
contamination of exposed plating.

Test Equipment Usage and ESD

— Before connecting any coaxial cable to any electronic equipment,
— Personnel should be grounded with a 1 megohm resistor-isolated
— Be sure that all equipment is properly earth-grounded to prevent build-up

For Additional Information about ESD

For more information about preventing ESD damage, contact the Electrical
Over Stress/Electrostatic Discharge (EOS/ESD) Association, Inc. The ESD
standards developed by this agency are sanctioned by the American National
Standards Institute (ANSI).
28
components.
momentarily short the center and outer conductors of the cable together.
wrist-strap before touching the center pin of any connector and before
removing any assembly from the analyzer.
of static charge.
Keysight CXG, EXG, and MXG X-Series Signal Generators Service Guide
Part Number
1401-0247
1252-5007
9300-0797
9300-0980
9300-1367