Keysight Technologies X Series Service Manual page 111

Service and Utility Menus
Utility Service Menu
Installed Board Info
This is a list of the installed board assembly information. The assemblies listed
here will vary depending on the model number and options installed.
5-12
Figure 5-12 Typical Installed Board Information
The part numbers of the assemblies on this screen will most likely not match
the part numbers found in the replacement parts list in
"Replacement
part numbers, not the replacement kit part numbers. These assembly part
numbers can be very important to know when servicing an instrument. For
example, service notes usually refer to the installed assembly part numbers, or
even the serial number or hardware ID.
If an instrument is not able to identify its model number, or some functionality
is missing, referring to the Installed Board Info screen can be helpful in
determining the possible cause of these types of problems. Of course, knowing
what assemblies and part numbers should be in this list would be important
information to know.
for the different model numbers in this series. Where there are multiple part
numbers for an assembly for a given model number, any one of them would be
correct. Also, these were the possible part numbers at the time of the printing
of this manual. Newer part numbers could be added later.
Keysight CXG, EXG, and MXG X-Series Signal Generators Service Guide
is an example of a typical Installed Board Info screen.
Parts". The part numbers listed here are the actual assembly
Table 5-1 lists the assemblies and possible part numbers
Figure
Chapter 14,
111