Step Operation - Mitsubishi Electric MELSEC-L LD75P Reference Manual

2.17 Step Operation

Function Overview
This program performs the step operation for Axis 1.
Program
This function uses the project (program name).
•LD-LD75_NML_V100A_E(17RunStp)
Applicable Hardware and Software
It is the same as "Applicable Hardware and Software" of "2.1 Parameter Setting".
System Configuration
It is the same as "System Configuration" of "2.1 Parameter Setting"
This program uses the following devices.
No. Device
1 X10
2 X37
3 Y10
Conditions for Using Sample Ladder Programs
It is the same as "Conditions for Using Sample Ladder Programs" of "2.1 Parameter Setting"
Devices
This program uses the following devices.
No. Device
1 X10
2 X37
3 Y10
4 M16
5 D20
6 D21
Data Type Application
Bit Axis 1 Start complete signal
Bit Step operation command
Bit Axis 1 Positioning start signal
Data Type Application
Bit Axis 1 Start complete signal
Bit Step operation command
Bit Axis 1 Positioning start signal
Bit Step operation command pulse
Word Step mode
Word Step valid flag
MELSEC-L LD75P/LD75D Positioning Module Sample Ladder Reference Manual
57/169
Remarks
-
-
-
Remarks
-
-
-
-
Sets the step mode setting
value.
Sets the step valid flag.
LDM-M022-A