Target Position Change - Mitsubishi Electric MELSEC-L LD75P Reference Manual

3.20 Target Position Change

Function Overview
This program performs the target position change for Axis 1.
Program
This function uses the project (program name).
•LD-LD75_IEF_V100A_E(20ChgPOS)
Applicable Hardware and Software
It is the same as "Applicable Hardware and Software" of "3.1 Parameter Setting".
System Configuration
It is the same as "System Configuration" of "3.1 Parameter Setting"
This program uses the following devices.
No. Device
1 X45
2 X100C
Conditions for Using Sample Ladder Programs
It is the same as "Conditions for Using Sample Ladder Programs" of "3.1 Parameter Setting"
Data Type Application
Bit Target position change command
Bit Axis 1 BUSY signal
MELSEC-L LD75P/LD75D Positioning Module Sample Ladder Reference Manual
153/169
Remarks
-
-
LDM-M022-A