Plc Ready Signal [Y0] On - Mitsubishi Electric MELSEC-L LD75P Reference Manual

2.6

PLC READY Signal [Y0] ON

Function Overview
This program turns ON the PLC READY signal [Y0].
Program
This function uses the project (program name).
•LD-LD75_NML_V100A_E(06OnRdy)
Applicable Hardware and Software
It is the same as "Applicable Hardware and Software" of "2.1 Parameter Setting".
System Configuration
It is the same as "System Configuration" of "2.1 Parameter Setting"
This program uses the following devices.
No. Device
1 Y0
Conditions for Using Sample Ladder Programs
It is the same as "Conditions for Using Sample Ladder Programs" of "2.1 Parameter Setting"
Devices
This program uses the following devices.
No. Device
1 SM403
2 Y0
3 M25
4 M27
5 M41
6 M50
7 M51
Data Type Application
Bit PLC READY signal
Data Type Application
Bit PLC READY signal [Y0] ON trigger
Bit PLC READY signal
Bit Parameter initialization command storage
Bit Flash ROM write command storage
Bit Absolute
storage
Bit Basic parameter 1 setting complete device
Bit OPR basic parameter setting complete device
MELSEC-L LD75P/LD75D Positioning Module Sample Ladder Reference Manual
position restoration
28/169
Remarks
-
Remarks
Turns OFF for one scan after
RUN.
-
-
-
instruction -
-
-
LDM-M022-A