Table of Contents
Advertisement
quill feed handwheel may be disengaged by moving them outward approximately
1
".
/
8
The feed control lever must be engaged in order to use
manual feed controls. The Quill Feed hand le and Manual
6-10 Feed Control Lever (#11 on 5HP & #12 on 3HP )
When this lever is moved left it engages over -load clutch on pinion shaft. Clutch
will remain engaged until either quill stop comes in contact with micrometer
adjusting nut (forcing feed control lever to disengage automatically), or lever is
released manually by moving it to the left.
The Feed Control Lever's factory default is to disengage
automatically when the quill stop pushes against t he
micrometer adjusting nut or throw adjustment. It may
easily be brought back by regulating the socket set screw
WHEN ADJUSTING THE S OCKET SET SCREW, CHE CK
DIRECTIONS: THAT IS WITH THE QUILL-STOP NUT
POSITION, AND AGAINS T REVERSE TRIP BALL
6-11 Quill Feed Handle (#1 7 on 5HP & #19 on 3HP )
May be removed by simply pulling handle off! It is recommended that ha ndle be
disengaged when using power feed.
6-12
Quill Stop K nob (#20 on 5HP & #11 on 3HP )
It is used to disengage power feed in either direction as well as acting as a depth
stop when working to a given depth.
6-13 Micrometer Adjusting Nut (#12 on 5HP & #15 on 3HP)
This nut is used for setting depth.
(0.02mm) and reads directly from the scale mounted along its side. Depths may be
adjusted by setting micrometer nut in conjunction with quill stop.
6-14 Quill Lock (#16 on 5HP & #17 on 3HP ):
This is a friction lock to be used when the quill is in a stationary position, such as
for milling. It is recommended this lock be used whenever quill movement is not
desired.
Feed Handwheel may be taken off when not in use.
located at the bottom of the tripping rod.
AUTOMATIC DISENGAGEM ENT IN BOTH
AGAINST THE FEED TRIP LEVER FOR DOWN
LEVER FOR THE UP POSITION.
NOTE
NOTE
CAUTION
Each graduation on nut indicates 0.001"
- 97 -
Advertisement
Table of Contents
