Acer e-mill 3VSII Operation Manual page 100

for heavier cuts with a minimum of vibration. The saddle locking lever is located
on the left-hand side of the saddle.
Excessive pressure can cause slight table bind. Use moderate clamping pressure, as
this will hold saddle sufficiently.
The table clamp levers are located on the front of saddle and should always be
clamped when longitudinal movement is not required.
For Model e-mill 3VS, 3VSII & 3VK
Figure 15. Table & saddle clamping lever
For model e-mill 3VKH, 5VK & 6VK
Figure 16. Table & saddle clamping lever
The knee clamping lever is at the left side of the knee and should be drawn upward
to clamp the knee.
completely. Leave clamped at all times unless using knee in operation.
Note: The two clamps on the left rear of the knee should only be used when
the knee will not be moved.
This is only a tension brake and will not lock the knee
- 99 -