Maintenance; Adjustment Of Table Gib; Adjustment Of Saddle And Knee Gibs - Acer e-mill 3VSII Operation Manual

Vertical turret w/ toshiba & fuji inverter
Table of Contents

Advertisement

7. MAINTENANCE

7-1 Adjustment of Table Gib:

The table is provided with a full length tapered gib in the saddle, and an adjusting
screw on the left side.
To take up gib, tighten g ib adjusting screw slightly and
repeat until a slight drag is felt when moving the table by hand.
For 3VS, 3VSII, 3VK
For 3VKH, 5VK & 6VK
Figure 18. Saddle/table gibs

7-2 Adjustment of Saddle and Knee Gibs

Adjustment of saddle gib
A tapered gib is used for adjusting the saddle bearing on the knee. This forms a
guide for the saddle. To tighten gib, remove chip wiper and use the same method
as described above. Replac e chip wiper after gib has been adjusted.
For 3VS, 3VSII, 3VK
For 3VKH, 5VK & 6VK
Figure 19. Saddle/knee gibs
- 103 -

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-mill 3vkhE-mill 3vsE-mill 5vkE-mill 3vkE-mill 6vk

Table of Contents

Save PDF