Table of Contents
Advertisement
DO NOT SHIFT HI-LO LEVER WHILE THE M OTOR IS
6-6 Power Feed Engagement Crank(#7)
Engages power feed worm gear. When lever is in right hand hole, power feed is
engaged.
To disengage, pull knob out and turn crank clockwise and move to
opposite position.
Handle must be moved in clockwise direction to engage or
POWER FEED GEAR MAY BE ENGAGED WHILE
SPINDLE IS TURNING. HOWEVER, IT SHOULD BE
ENGAGED SLOWLY TO AV OID DAMAGE TO THE
WORM GEAR. THE GEAR MAY BE DISENGAGED AT
ANY TIME. DO NOT USE POWER FEED AT SPEEDS
WORM GEAR BE DISENGAGED WHENEVER THE
POWER FEED IS NOT RE QUIRED. THIS WILL AVOID
UNNECESSARY WEAR ON PWER FEED WORM GEAR.
6-7 Quill Feed Selector (#8)
This crank is used to select the feed rate.
turning from one position to another. Feed rates are stamped on cover below each
hole. Feed is more readily engaged with spindle running.
6-8 Feed Reverse Knob (#10 )
Position of this knob depends upon direction of spindle rotation.
right hand cutting tools, pull feed handle towards operator until clutch becomes
engaged.
Neutral position is between forward and reverse position. It is recommended that
he handle be left in neutral position when not in use.
6-9 Manual Feed Handwheel (#9 )
Feed reversing knob should be in neutral position and fe ed control lever engaged.
Clockwise rotation of handwheel moves quill down. Manual Feed Handwheel and
disengage power feed. If handle is moved counter -
clockwise no damage will be done, but nothing will
ABOVE 3000 RPM.
IT IS RECOMMENDED TH AT THE POWER FEED
CAUTION
RUNNING.
NOTE
happen.
CAUTION
IMPORTANT
It is shifted by pulling knob out and
- 96 -
If boring with
Advertisement
Table of Contents
