April 14, 2006
Add a New Session
Step
1
On the WAN Session Management menu, enter 2 to add a new session. The Create new session menu
is displayed
(Figure
2
Select one of the following protocols for this session:
1—Create RFC 1483 bridged session if the modem forwards packets based on MAC addresses.
You can enable Spanning Tree when you select Bridge sessions. See
Setting" on page
2—Create RFC 1483 routed session if the modem routes packets based on IP addresses.
3—Create PPPoA routed session if the modem establishes PPP sessions over ATM with the
service provider and routes packets based on IP addresses.
4—Create PPPoE routed session if modem establishes PPP sessions over Ethernet with the
service provider and routes packets based on IP addresses.
MM70xG2-UM-03
A-8).
Figure A-8. Create New Session
5-10.
Appendix A: Command Line Interface Access
Action
"Change Spanning Tree
A-9