Inspecting Your Shipment; Fcc Classb Compliance; Eu Compliance - ADC MM701G2 User Manual

Adc telecommunications megabit modem user manual mm701g2, mm702g2
Table of Contents

Advertisement

About This Manual
Reader Alert
Alerts you to possible equipment damage from electrostatic discharge
ATTENTION
Alerts you to possible data loss, service-affecting procedures, or other similar type
CAUTION
problems
Alerts you that failure to take or avoid a specific action might result in hardware damage or
WARNING
loss of service
Alerts you that failure to take or avoid a specific action might result in personal harm
DANGER
I
Y
NSPECTING
OUR
Upon receipt of the equipment:
• Unpack each container and visually inspect the contents for signs of damage. If the equipment has been dam-
aged in transit, immediately report the extent of damage to the transportation company and to ADC. Order
replacement equipment, if necessary.
• Check the packing list to ensure complete and accurate shipment of each listed item. If the shipment is short
or irregular, contact ADC as described in
equipment for a prolonged period, store the equipment in its original container.
FCC C
B C
LASS
OMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
EU C
OMPLIANCE
This product has been CE marked in accordance with the requirements of European Directive 73/23/EEC; the
following mentioned product is in conformity with Low Voltage Directive 73/23/EEC in order to comply with the
requirements in the Council Directive 73/23/EEC relating to electrical equipment designed for use within certain
voltage limits and the Amendment Directive 93/68/EEC.
For safety evaluation of the compliance with this Directive 73/23/EEC, these standards were applied: IEC
60950:1999, EN 60950:2000.
xiv
S
HIPMENT
Appendix C: Product Support on page
Meaning
April 14, 2006
C-1. If you must store the
MM70xG2-UM-03

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mm702g2

Table of Contents