ADC MM701G2 User Manual page 51

April 14, 2006
Step
2 To add a new SNMP community, do the following:
a. On the SNMP Community List page, click Add a new community. The following dialog is
displayed
b. Enter the following information for the SNMP community.
– Name
Identification for this SNMP community. All keyboard characters are allowed for this name, up to
a maximum of 80 characters. You must add a community name in this field to later edit or delete
the SNMP community. This name in the SNMP Community List table provides the link for
editing or deleting the entry.
– Access Privilege
The access allowed to this SNMP community. Accesses are either Read (view-only access) or
Write (full view and write access).
c. Click Add. The new entry is added to and is displayed in the SNMP Community List table (see
page 5-8).
MM70xG2-UM-03
(Figure 5-9).
Figure 5-9. Add New Community
Chapter 5: Configuring System Parameters
Action
5-9