ADC MM701G2 User Manual page 42

Chapter 4: Configuring the WAN
Step
2 The following (Figure
(cont.)
The Protocol field at the top of the dialog is read-only. It indicates the protocol that you previously
selected for this session.
3 Change session parameters as required. Go to the following pages for parameter definitions based on
the protocol used for that session:
• For an RFC1483-Bridge session, go to page 4-3.
• For an RFC1483-Routed session, go to page 4-5.
• For a PPPoA Routed session, go to page 4-7.
• For a PPPoE Routed session, go to page 4-7.
4 Do one of the following:
• Click Apply, then save changes as described in
• Click Delete to entirely remove the session, then save changes as described in
page 5-12.
4-12
4-7) shows the fields you can edit for a PPP session or you can delete the session.
Figure 4-7. WAN Sessions (PPP)
Action
"Saving Changes" on page
April 14, 2006
5-12.
"Saving Changes" on
MM70xG2-UM-03