3. Diagnosis PROFIBUS-DP
Festo P.BE-CP-DI01-EN en 0007a
Diagnostic possibilities
As a slave on the PROFIBUS-DP the CP system offers exten-
sive diagnostic possibilities via the PROFIBUS-DP.
Please note
The diagnostic information is only sent to the master
system when device-related diagnosis is activated in the
switch module. To do this, set switch element 8 of the
8-element DIL switch to "ON".
The diagram below shows the steps which are important for
diagnosing the CP system.
7
6
5
4
3
2
1
1
Fig. 3/7: First diagnostic step
0
Bit
1
Station status 1
CPV Direct is without voltage
or the bus plug is not inserted
Planned extension of the CP
system is not the same as the
extension set with the DIL
switch (see chapters 3.2 and
1.8)
3-9