Festo CPV-DI01 Manual page 43

1. Installation
1
Cables
2
Strain relief
3
Housing
4
Connecting part
Fig. 1/20: Individual socket parts and cable routing
Preparing the cables
Festo P.BE-CP-DI01-EN en 0007a
1
4
When you have selected suitable cables, connect them as
follows (Fig. 1/20):
1. In order to open the sockets, loosen the centre knurled
nut.
2. Open the strain relief on the rear of the housing. Then
pass the cable through.
3. Remove 5 mm of the insulation and fit end sleeves onto
the wires.
4. Connect the conductors.
5. Insert the connecting part into the housing of the plug
again. Pull the cable back so that there are no loops in-
side the housing.
6. Tighten the strain relief.
2
3
1-29