Siemens LMV5 Series Technical Instructions page 294

Technical Instructions
Document No. LV5-1000
9-2: ACS450 Software Installation
The following steps outline the procedure for installing the ACS450 software on a PC:
1. The ACS450 software can be acquired in a couple of ways:
a. Download it from the SCC website: www.scccombustion.com/acs450_form.htm
• After filling out a short form, you will receive an e-mail containing the Username and
Password required to download the software. Once the Username and Password
are acquired, use the "click here" link on the same webpage in order to start the
download.
b. Download it from SCC's Combustion CD.
c. Acquire it via an e-mail attachment.
2. The files shown below must reside in the same folder on the PC or on the CD before
proceeding.
• acs450.msi • InstMsiA.exe • InstMsiW.exe
Double-click on the setup.exe file. This should start the installation. Pick the desired options as
the installation prompts.
3. Once installed, the files will be located on the computer's hard drive at one of the following
locations:
C:\Program Files (x86)\ACS450
C:\Program Files (x86)\Siemens AG\ACS450
4. Open these folders and check to make sure that all of the .cod files listed below are there.
These are necessary for the AZL5 to communicate properly with the ACS450 software.
• Para_Nr_0400.cod
• Para_Nr_0450.cod
• Para_Nr_0480.cod
• Para_Nr_0510.cod
Any missing .cod files can be acquired from the SCC Combustion CD or by emailing
techsupport@scccombustion.com.
5. At this point, the ACS450 is ready to run. The first time ACS450 is started it will prompt for a
license code. When prompted, type the following license code: 041028000703GH.
Section 9
• Para_Nr_0410.cod
• Para_Nr_0460.cod
• Para_Nr_0490.cod
Page 2
HOME
• setup.exe • setup.ini
• Para_Nr_0420.cod
• Para_Nr_0470.cod
• Para_Nr_0500.cod
LMV Series
SCC Inc.