Table of Contents
Advertisement
Orion
Revision 3.0
25 July 2016
Alarm Displays
Note:
MESSAGE
NO CONTROL POWER
CARRIAGE GATE
OPEN DURING CYCLE
END OF ROLL OR
BROKEN FILM
CARRIAGE MOVING
UP TOO SLOWLY
CARRIAGE MOVING
DOWN TOO SLOWLY
(NAME) CONVEYOR
TIMEOUT FAULT
CARRIAGE DOOR
OPEN
The messages in this section are the various critical status messages. For non-critical
alarms, see "Message Displays" on page 3 - 46.
Correct the condition and press the Fault Reset button to clear the message and continue
machine operation. A description of these messages appears on the following pages.
Not all messages in this list are applicable to your machine. The
alarm messages on you machine may vary based on machine
options.
Table 3-33. The Information and Alarm Displays
DESCRIPTION
Control Power is not present.
The carriage gate opened during the cycle.
The film has broken or the roll ran out.
The carriage is moving upward too slowly.
The carriage is moving downward too slowly.
The indicated conveyor sensor didn't change
states within the time required in the system pro-
gram.
The carriage door is currently open.
Machine Manual
CTS Flex Stretchwrapper
System Operation
CORRECTION
Press the Control Power reset
button prior to starting the
machine.
Check for the cause of the
unlatch. Re-latch and restart,
when ready.
Re-load a new roll if out. If bro-
ken, monitor the film. Replace
roll if problem persists. See trou-
bleshooting chart for broken film
troubleshooting tips.
Check for the cause of the car-
riage not moving correctly.
Check the belt drive behind the
back panel. Check for a jam or
obstruction on the track.
Check for the cause of the car-
riage not moving correctly.
Check the belt drive behind the
back panel. Check for a jam or
obstruction on the track.
Check that the load isn't hung
up. Ensure that the load indexes
properly. Check photoeye align-
ment.
Close the carriage door to allow
operation.
Page 3-51
Advertisement
Table of Contents
