Table of Contents
Advertisement
Orion
Revision 3.0
25 July 2016
All H&L Heavy Duty (Ring Bearing) Series
5,760 Loads Or One Month
•
Inspect rubber stretch rollers. Clean as needed per instructions in manual.
•
Inspect belt condition. Adjust as needed.
17,280 Loads or three months.
•
Inspect under turntable. Clean debris as needed.
•
Inspect turntable support casters for good condition.
•
Inspect turntable chain. Apply a light coating of lubricant per instructions in manual.
•
Inspect prestretch chain and belt. Tension as needed. Apply a light coating of lubricant
per instructions in this manual.
34,560 Loads or 6 months.
•
Lubricate ring bearing per instructions below.
Ring Bearing Maintenance (If Applicable)
The ring bearing should be re-lubricated internally and externally.
Internally: Locate the grease zerk located directly on the ring bearing. Pump one full shot
of grease into the zerk every six months. This should be plenty of lubrication for most
applications. Pumping too much grease into the ring bearing can destroy the ring bearing
by dislocating the rubber grease seal.
Externally: by lubricating and wiping the chain drive with oily cloth. The frequency of
lubrication depends on entirely upon the usage of the machine and environment in which
the machine is placed (dust, moisture etc.). Machines working under extremely dirty con-
ditions should be lubricated every 400 operating hours but at minimum, every 2 months.
Longer lubrication intervals may occur only when machine is working under very clean
and dry conditions but should be not be longer than 6 months.
List of recommended lubricants for the ring bearing lubrication.
Table 5-3. Recommended Ring Bearing Lubricants
MANUFACTURER
BP
Castrol
Esso
Gulf
Mobil
Shell
Texaco
Valvoline
Machine Manual
CTS Flex Stretchwrapper
Maintenance
LUBRICANT
Energrease LS2
Speeroll AP2
Beacon 2
Crown Grease 2
Mobilus 2
Avania Grease R2
Glissando FT 2
LB-2
Page 5-7
Advertisement
Table of Contents
