S Insta-Cut Screen; The S Insta-Cut Screen - Pro Mach Orion CTS Flex Stretchwrapper Manual

Machine Manual
CTS Flex Stretchwrapper
System Operation

S Insta-Cut Screen

Figure 3 - 25
The S Insta-Cut
Screen
Table 3-24. The Insta-Cut "S" Screen Button Descriptions
STATE 1
INSTA- CUT ENABLED
INSTA-CUT PUNCH
POSITION
INSTA-CUT PUNCH
DWELL
INSTA-CUT BRAKE
POSITION
INSTA-CUT TEAR
DURATION
INSTA-CUT SPEED HZ
Page 3-34
This is the S Insta-Cut screen. This screen allows adjustments to the timing and speed set-
ting associated with the Insta-Cut on the HPS or LPS machines, if so equipped.
DESCRIPTION
Press this button to toggle between Insta-Cut On or
Insta-Cut Off. This allows the operator to disable the
Insta-Cut function.
Press this button to modify the Insta-Cut Punch Position. This is the tooth count
position at which the Insta-Cut puncher activates to punch a hole in the film.
Press this button to modify the Insta-Cut Punch Dwell. This is the amount of teeth
that the Insta-Cut puncher will stay activated to create a hole in the film.
Press this button to modify the Insta-Cut Brake Position. This is the tooth count
position at which the Multistretch will stop paying out film, which causes the film
to tear. Min - (Insta-Cut Punch Position + Insta-Cut Punch Dwell)
Press this button to modify the Insta-Cut Tear Duration. This is the amount of teeth
that the Main Drive will continue to travel at the predefined Insta-Cut Speed before
slowing down to Jog Speed and stopping at home.
Press this button to modify the Insta-Cut Speed. This is the speed at which the Main
Drive will travel during the Insta-Cut sequence.
Orion
Revision 3.0
25 July 2016
STATE 2
INSTA-CUT DISABLED