Table of Contents
Advertisement
Machine Manual
CTS Flex Stretchwrapper
System Operation
Table 3-32. The Information and Alarm Displays (Continued)
MESSAGE
CARRIAGE GATE
OPEN
HOMING MACHINE
LOW AIR PRESSURE
PRESS START BUTTON
TO RESET CONTROL
POWER
MOVING TO BOTTOM
OF LOAD
MOVING TO TOP OF
LOAD
CARRIAGE
OBSTACLE DETECTED
- CLEAR & PRESS
RESET
READY TO WRAP -
PRESS & HOLD START
BUTTON
APPLYING
REINFORCEMENT
WRAPS
TOWER OBSTACLE
DETECTED
APPLYING BOTTOM
WRAPS
WRAP CYCLE IS
COMPLETE
Page 3-48
DESCRIPTION
The carriage gate is currently open.
The machine is homing.
The machine pneumatic pressure is low.
The machine is not reset.
The carriage is moving to the bottom of the load.
The carriage is moving to the top of the load.
The obstacle detection is tripped.
The machine is reset and ready to run.
Reinforce wraps are currently being applied.
The tower has an obstruction.
The bottom wraps are currently being applied.
The wrap cycle is now complete.
Revision 3.0
25 July 2016
CORRECTION
Close the carriage to allow oper-
ation. Check the interlock
switch.
Allow the machine to home prior
to starting.
Check the pneumatic supply.
Ensure 80 PSI is available.
Press Start to reset control power
prior to starting.
This is for informational pur-
poses only. No correction neces-
sary.
This is for informational pur-
poses only. No correction neces-
sary.
See "Carriage Obstacle Detect
Error Recovery" on page 3 - 2.
Press and hold the start button
for the amount of time set in the
parameters to start the machine.
Once the reinforce wraps are
completed, the machine will
continue its cycle.
Check for a mechanical bind.
Clear the cause of the fault.
Reset and restart, when ready.
This is for informational pur-
poses only. No correction neces-
sary.
Remove the load, when ready.
Orion
Advertisement
Table of Contents
