Table of Contents
Advertisement
Machine Manual
CTS Flex Stretchwrapper
Troubleshooting
PROBLEM
Carriage Lift
(Up & Down)
Carriage Will Not Move Up Or
Down (In Either Manual Mode
Or During An Auto Wrap
Cycle)
Page 4-6
Table 4-1. Troubleshooting Chart (Continued)
POSSIBLE CAUSE
Carriage Speeds set below 5%.
Carriage Travel limit strikers set
improperly.
Lift Belt Error (Visible obstruc-
tion) has occurred.
VFD parameter settings are
incorrect.
SOLUTION
Check the numerical value of the carriage
up and down speeds on the touchscreen.
Password may be required depending on
the Security Settings.
Increase the carriage up and down speeds
on the touchscreen to above 5%.
Check the physical positions of the travel
limit strikers.
1. Set the Up Travel limit striker to the
highest wrapping requirement position
within the machine's capability or a jam
may occur.
2. Position the Bottom travel striker to the
lowest wrapping requirement level within
the machine's capability or a false Belt
Error may occur.
Check for a physical obstruction in the
carriage toward travel path and Lift Belt
Error shown on the touchscreen.
If there is an actual obstruction, refer to
the "Carriage Obstacle Detect Error
Recovery" inset in your manual.
Review the parameter settings in the VFD.
Refer to the supplied VFD Manual for
procedure.
Refer to the VFD manual and the Orion
parameter settings sheet supplied with the
machine for maximum frequency settings.
Orion
Revision 3.0
25 July 2016
Advertisement
Table of Contents
