Table of Contents
Advertisement
Machine Manual
CTS Flex Stretchwrapper
System Operation
Information & Alarm Messages
Message Displays
Note:
MESSAGE
MACHINE SETUP
REQUIRED - SELECT
MACHINE OPTIONS
APPLYING TOP
WRAPS
END OF FILM ROLL
OR BROKEN FILM
CYCLE ENDING
CYCLE PAUSED
E-STOP PRESSED
Page 3-46
The message and alarm displays are divided into two separate charts in this section.
•
Message Displays - Various non-critical status messages
•
Alarm Displays - Operation critical alarms/faults
The messages in this section are the various non-critical status messages. These messages
are for informational purposes. For critical alarms, see "Alarm Displays" on page 3 - 51.
Not all messages in this list are applicable to your machine. The
alarm messages on you machine may vary based on machine
options.
Table 3-32. The Information and Alarm Displays
DESCRIPTION
The machine setup parameters are not set.
The machine is currently applying the top wraps.
The film has broken or the roll ran out.
The cycle is ending.
The cycle is paused.
The E-stop button is currently pressed.
Revision 3.0
25 July 2016
CORRECTION
See "Machine Setup Screen" on
page 3 - 25.
This is for informational pur-
poses only. No correction neces-
sary.
Re-load a new roll if out. If bro-
ken, monitor the film. Replace
roll if problem persists. See trou-
bleshooting chart for broken film
troubleshooting tips.
This is for informational pur-
poses only. No correction neces-
sary.
Resume, when ready. Press the
resume button on the Run
screen.
Release the E-stop button to
allow operation. Press Start to
reset control power, then press
and hold start for the amount of
time set up in the parameters.
Orion
Advertisement
Table of Contents
