Pro Mach Orion CTS Flex Stretchwrapper Manual page 36

Stretch-wrapping equipment
Table of Contents

Advertisement

Machine Manual
CTS Flex Stretchwrapper
System Operation
Table 3-2. The Run Screen Button Descriptions (Continued)
STATE 1
Page 3-6
DESCRIPTION
Press this button to wrap the load again. The same wrap parameters are used.
Press this button to index the load to the exit conveyor. This button is available on
certain machine configurations when the machine is reset.
Press this button to apply the predefined reinforce-
ment wraps to the load. If the Reinforcement Wraps
value is set to zero, reinforcement wraps will be
applied as long as the Reinforce button is pressed.
Press this button to stop the current wrap cycle.
Press this button to reset the current fault condition.
Press this button to toggle between High Speed and Low Speed operation. When
High Speed is selected, the Main Drive will travel at the predefined High Speed
value during the wrap cycle. When Low Speed is selected, the Main Drive will
travel at the predefined Low Speed value during the wrap cycle.
Press this button to send the machine to its Home Position. When pressed, the Car-
riage will travel to its bottom limit, and the Main Drive will travel to its predefined
End of Cycle Position.
Orion
Revision 3.0
25 July 2016
STATE 2
REINFORCING

Advertisement

Table of Contents
loading

Related Products for Pro Mach Orion CTS Flex Stretchwrapper

Table of Contents