Step 6 - Pinning The Rods To Engage The Deadbolt Lever; Step 7 - Installation Of Inside And Outside Trim - Assa Abloy Yale 7370 Series Installation Instructions Manual

Step 6 – Pinning the Rods to engage the Deadbolt Lever
Hole shown in proper pinning position.
The Lifting Platform Jig and the Top Clamp can now be removed from the shutter.
8
An ASSA ABLOY Group brand
Drive Pin
Step 7 – Installation of Inside and Outside Trim
• Loosen the Drill Guide clamping screw allowing
the Drill Guide to be removed from the shutter.
• Manually retract the deadbolt by applying force
to the deadbolt lever toward the top of the
shutter.
• This will put the pinning hole in the proper
position for fastening the Drive Pin.
• Insert the Drive Pin from the underside of the
shutter and through the holes in the rods and
fasten the Drive Pin in place with the spring
washer.
• Install the outside trim by inserting it from
underneath the shutter (outside face).
• As it enters the shutter cavity the lifting pad in
the escutcheon will rest on the underside of the
lifting pad secured to the rods in step 4.
• Press the outside escutcheon against the
shutter surface.
• Install the inside trim by placing it over the
shutter prep and positioning the lifting pad of
the inside trim on the underside of the lifting
pad.
• Visually align the mounting holes of the inside
escutcheon to the mounting posts from the
outside escutcheon.
• Insert 4 mounting screws #12 -24 x 1-1/2" and
tighten screws.
80-8470-7370-010 (10-12)