Table of Contents
Advertisement
Step 2 – Installation of the Bottom Bolt Assembly continued
Nylon Guides
4
An ASSA ABLOY Group brand
Step 3 – Installation of the Top Pusher Assembly
Strike Plate
Note beveled edge position
Plunger Pin
Top Pusher
Assembly
•
With the Deadbolt Retracted, slide the Bottom Bolt
Sub Assembly into the prep. hole in the bottom of the
shutter. As you guide the assembly up into the shutter
you will need to guide it into the bottom nylon guide of
the Deadbolt Assembly and then up thru the top nylon
guide.
• Seat the bottom bolt bracket against the shutters lower
reinforcement plate.
• Align Bottom Bolt Plate to shutter prep.
• Fasten the Bottom Bolt Assembly and Bottom Bolt
Plate to the bottom of the shutter using (2) #12-24 x 1"
Flat Head Cap Screws.
•
Slide this assembly into the prep. at the top of the
shutter, making sure the plunger pin is oriented with
the clearance slot on the stop side of the shutter.
• Visually align the rod of the Top Pusher Assembly so
that it enters the tube of the Bottom Bolt Assembly
that extends out of the Deadbolt Assembly.
• Align the Top Strike plate to shutter prep. noting the
position of the beveled edge. It should be on the
same side as the plunger pin.
• Fasten the Top Strike plate and Top Pusher Assembly
to the top of the shutter using (2) #12-24 x 1" Flat
Head Cap Screws.
80-8470-7370-010 (10-12)
Advertisement
Table of Contents
