Installation; Install Adapter Clutch; Install Outside Lever Assembly - Assa Abloy Corbin Russwin BLSS ML2000 Series Installation Instructions Manual

BLSS Freewheeling Trim Retrofit
ML2000 Series
Installation Instructions
4

Installation

a

Install Adapter Clutch

Install adapter clutch into mortise
lock hub. (Figure 6)
Note:
Adapter clutch is oriented toward
latchbolt as shown.
b

Install Outside Lever Assembly

Use outside bushing and spindle to connect
rose/adapter plate assembly to outside lever
assembly. (Figure 7)
• Insert spindle into bushing; ensure that
spindle is inserted no more than ¾" deep.
• Use spindle to rotate bushing
clockwise into outside lever hole.
• Fully tighten bushing, then unthread
bushing just enough to allow spindle to
be inserted into lever, keeping
bushing as tight as possible.
• Once assembled, spindle orientation
should be as shown. (Figure 8)
Note:
Longer spindle used on outside
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Outside Lever Assembly
Align rose screw with gap in spring cartridge
Figure 7
857F658
Adapter Clutch
Figure 6
857F598 Spindle
Apply grease to
these surfaces
Rose/Adapter Plate Assembly
RH Outside
Note position
and orientation
of spindles.
Figure 8
5
Bushing
(Outside)
LH Outside
FM522 08/19