Installation: Cl3100 Lever Lock With High Security Lever (M111); Assemble Lock Body; Install Security Attachment Screw; Install Lever - Assa Abloy Corbin Russwin CL3100 Series Installation Instructions Manual

Grade 1 Key-In-Lever VR Lever Lock
CL3100 Series
Installation Instructions
14

Installation: CL3100 Lever Lock with High Security Lever (M111)

a

Assemble Lock Body

1. Prep door and install lock bearing and latch according to door and frame preps that appear on page 3 step 1.
2. Complete assembly of lock with security lever attachment according to the following steps.
b

Install Security Attachment Screw

1. Using screwdriver provided, unscrew the security
attachment screw from lever catch on the outside
sleeve.
Important
Keep screw for reinstallation.
2. Install outside and inside sleeves and roses
according to sleeve installation instruction on
page 6 step 6.
Note
The cam in the outside sleeve must be rotated so
the large slot is horizontal. This allows the security
screw to thread into the cam. See cam orientation,
page 7 step 7.
3. Insert the security attachment screw into lever
catch assembly and tighten until screw head is
within approximately 1/8" of lever catch. Do not
overtighten.
c

Install Lever

Important
Before installing levers read "Specific Instruction Per Function - Before
Installing Lever" on page 6.
1. Place cylinder in outside lever. Insert key and rotate 45° clockwise.
2. With key rotated, push lever onto sleeve until hole on inside of lever
is over security attachment screw. If screw interferes with assembly,
check that screw is fully threaded into lever catch.
3. Using screwdriver provided, rotate security attachment screw
counter clockwise until flush with surface of lever.
4. Secure lever with 6 lobe security set screw.
5. Rotate key to horizontal and remove.
For Installation Assistance contact Corbin Russwin
1-888-607-5703 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2016, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
cam
Cam
lever catch
Lever catch
security attachment screw
Security attachment screw
1
1
Screwdriver screwdriver
Figure 21
Security Attachment Screw
3
Figure 22 Install Lever
12
outside sleeve
Outside sleeve
3
3
2
4 6 lobe Security
6 lobe security
Wrench
wrench
45°
5
45°
1
FM345 01/19