Table of Contents
Advertisement
Hole shown in proper pinning
position.
The Lifting Platform Jig and the Top Clam p can now be removed from the shutter.
Step 7 – Installation of Inside
ASSA ABLOY, the global leader in door opening solutions
Drive Pin.
and Outside Trim
Step 6 – Pinning the Rods to
engage the Deadbolt Lever
· Loosen the Drill Guides clamping
screw allowing the Drill Guide to be
removed from the shutter.
· Manually retract the Deadbolt by
applying force to the deadbolt lever
toward the top of the shutter.
· This will put the pinning hole in the
proper position for fastening the Drive
Pin.
· Insert the drive Pin from the underside
of the shutter and through the holes in
the rods and fasten the Drive Pin in
place with the spring Washer.
· Install the outside trim by inserting it
from underneath the shutter (outside
face).
· As it enters the shutter cavity the lifting
pad in the escutcheon will rest on the
underside of the lifting pad secured to
the rods in step 4.
· Press the outside escutcheon against the
shutter surface.
· Install the inside trim by placing it over
the shutter prep and positioning the
lifting pad of the inside trim on the
underside of the lifting pad.
· Visually align the mounting holes of the
inside escutcheon to the mounting posts
from the outside escutcheon.
· Insert 4 mounting screws ¼" – 20 by
1 ¾" and tighten screws.
8
Advertisement
Table of Contents
