Table of Contents
Advertisement
Passport 1000 PG
Mortise Lock
10
Installation Instructions - Installation of Cylinder
Note: For proper cylinder/parts orientation see Figure
10A. Slide cylinder through the spring and rosette/
collar and screw into lockbody, rotating the cylinder
clockwise.
Cylinder should be fl ush with rosette/collar.
Note: SARGENT logo must be horizontal and on the
top of the cylinder (Figure 10B).
1. Secure the cylinder by tightening cylinder clamp
screw located above the deadbolt.
2. Using the key, verify that the key retracts the
latchbolt (and deadbolt).
11
Installation Instructions - Deadbolt Functions Only (82276 & 82277)
1. Insert alignment tool (supplied) into lock body thumb
turn.
2. Slide back plate over tool and make level.
3. Secure back plate to door with two (2) #6 x 3/8" round
head wood screws or #6-32 x 3/8" round head machine
screws.
4. Dispose of tool, position thumb turn over back plate
(Figure 11) and secure with #6-32 x 1/4" fl at head screw.
Note: Thumb turn should cover screw head when deadbolt is
retracted.
5. Refer to instructions (A5675G) included in package
included with lock.
1-800-727-5477 • www.sargentlock.com
Copyright © 2012, 2022, SARGENT Manufacturing Company. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing
Company is prohibited. Patent pending and/or patent www.assaabloydss.com/patents.
Position cylinder so that the SARGENT
logo is right-side up.
Correct
Incorrect
Figure 10B
Alignment Tool
Figure 11 Detail
Rosette must
be oriented as
shown
Figure 10A
11
Align cylinder groove
with tapped hole, then
tighten set screw to
hold lock cylinder
Back Plate
#6 x 3/8" Round Head
Wood Screws
#6-32 x 3/8" Round
Head Machine Screws
Thumb Turn
#6-32 x 1/4"
Flat Head Screw
Figure 11
A7807D 12/22
Advertisement
Table of Contents
