Table of Contents
Advertisement
FM6100 Series Multi-Point Lock
Pinning the Rods to engage the Deadbolt Lever
6
• Loosen the Drill Guides clamping screw allowing the Drill
Guide to be removed from the shutter.
• Manually retract the Deadbolt by applying force to the
deadbolt lever toward the top of the shutter.
• This will put the pinning hole in the proper position for
fastening the Drive Pin.
• Insert the Drive Pin from the underside of the shutter and
through the holes in the rods and fasten the Drive Pin in
place with the spring washer.
The Lifting Platform Jig and the Top Clamp can now be
removed from the shutter.
Installation of Inside and Outside Trim
7
• Install the outside trim by inserting it from underneath
the shutter (outside face).
• As it enters the shutter cavity the lifting pad in the
escutcheon will rest on the underside of the lifting pad
secured to the rods in step 4.
• Press the outside escutcheon against the shutter
surface.
• Install the inside trim by placing it over the shutter
prep. and positioning the lifting pad of the inside trim
on the underside of the lifting pad.
• Visually align the mounting holes of the inside
escutcheon to the mounting posts from the outside
escutcheon.
• Insert 4 mounting screws #12 – 24 by 1 ½" and
tighten screws.
8
www.sargentlock.com • A8058:A
Hole shown in proper
pinning position.
Advertisement
Table of Contents
