Final Mortise Lock And Trim Installation; Electronic Access Control (Eac) Reader And Controller Installation; Deadbolt Label Installation (Fm7300 Only); Key Override With Deadbolt Function Operation Check - Assa Abloy SARGENT FM7300 Series Installation Instructions Manual

Multi-Point Lock
FM7300 Series and BL7300 Series
Installation Instructions
3 Installation (cont.)
j

Final Mortise Lock and Trim Installation

Follow the supplied mortise lock installation instructions for trim and other function related hardware.
k

Electronic Access Control (EAC) Reader and Controller Installation

Follow supplied EAC Installation Instructions (if applicable).
l

Deadbolt Label Installation (FM7300 Only)

Install the deadbolt label on the inside of the door. (Figure 25)
m

Key Override with Deadbolt Function Operation Check

Verify hand and bevel of door to determine direction to rotate key and lever. Stand on outside of locked
door when determining door hand. (Figure 26)
1. Rotate key to retract latch and hold. (Do not touch lever).
2. Continue holding key, rotate lever with other hand and open door. (Figure 27)
Note:
Graphic is for reference only;
it does not represent all
door hand options.
1-800-727-5477 • www.sargentlock.com
Copyright © 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or in
part without the express written permission of SARGENT Manufacturing Company is prohibited.
Left Hand
Hinges Left.
Open Inward.
(LH)
Left Hand
Reverse Bevel
Hinges Left.
Open Outward.
(LHRB)
1
2
RH
13
Figure 25
Right Hand
Hinges Right.
Open Inward.
(RH)
Figure 26
1
2
LH
Figure 27
Right Hand
Reverse Bevel
Hinges Right.
Open Outward.
(RHRB)
A8220D 04/20