Table of Contents
Advertisement
Set Screw
An ASSA ABLOY Group brand
Step 1 – Installation of the Deadbolt Assembly
Lower Thru
Bolt Cutout
Step 2 – Installation of the Bottom Bolt Assembly
•
• When you insert the assembly into the shutter and
Continue on next page.............
• Place the window shutter on a horizontal surface
with the pin lever notch located at the top of the
shutter facing up.
• The recommended deadbolt assembly location
should be equidistant from the top and bottom
of the shutter.
• Assemble the deadbolt case into the lock pocket
provided in the door. Note the orientation of the
lock, the top of the deadbolt case indicates that
this should be toward the top of the shutter.
• Assemble the lock to the edge of the shutter
using (2) 1/4-20 x 1" Flat Head Cap Screws.
Loosen the set screw so that the lifting platform will
slide along the lower rod tubing but not slide on its
own when the rod is held vertically. Be sure that the
set screw is oriented so that it will be accessible
through the Lower Thru Bolt Cutout on the top side of
the shutter.
through the nylon guides of the deadbolt case this
lifting pad will be in a position to allow you to make the
final necessary adjustment. Note the orientation of the
bottom bolt assembly the double screw head side (not
shown in this image) should be facing the hinge side
of the shutter.
3
80-8470-7370-010 (10-12)
Advertisement
Table of Contents
