Final Mortise Lock And Trim Installation; Electronic Access Control (Eac) Reader And Controller Installation; Deadbolt Label Installation (Fe6600 Only); Key Override With Deadbolt Function Operation Check - Assa Abloy Corbin Russwin FE6600 Series Installation Instructions Manual

FE6600 and BL6600 Series
Multi-Point Lock
Installation Instructions
3 Installation (cont .)
j

Final Mortise Lock and Trim Installation

Follow supplied mortise lock installation instructions for trim and other function related hardware.
k

Electronic Access Control (EAC) Reader and Controller Installation

Follow supplied EAC Installation Instructions (if applicable).
l

Deadbolt Label Installation (FE6600 Only)

Install deadbolt label on inside of door. (Figure 25)
m

Key Override With Deadbolt Function Operation Check

Verify hand and bevel of door to determine direction to rotate key and lever. Stand on outside of locked
door when determining door hand. (Figure 26)
4. Rotate key to retract latch and hold. (Do not touch lever).
5. Continue holding key, rotate lever with other hand and open door. (Figure 27)
Note:
Graphic is for reference only;
it does not represent all
door hand options.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Left Hand
Hinges Left.
Open Inward.
(LH)
Left Hand
Reverse Bevel
Hinges Left.
Open Outward.
(LHRB)
Figure 26
1
2
RH
13
Figure 25
Right Hand
Hinges Right.
Open Inward.
(RH)
1
2
LH
Figure 27
Right Hand
Reverse Bevel
Hinges Right.
Open Outward.
(RHRB)
FM440 03/20